Explore More!

+27(0)11-792-6034
astro@technopro.co.za

Manufacturers

Manufacturer Info

Cards Accepted

VisaMasterCardAmerican ExpressDiners Club

Who's Online

There currently are 244 guests online.

Tork Craft Diamond Core Bit 30mm For Tiles

R140.00


Add to Cart:



  • Model: VER/TC180830
  • Shipping Weight: 0.066kg
  • Manufactured by: Tork Craft

  • 6009515802400


Ask a question about this item


Ø30mm Diamond core bit

Application:

The diamond core bit is used to drill holes in:

  • Ceramic tiles
  • Marble
  • Grade 5 porcelain (hardest)
  • Granite
  • Glass
  • Slate

The diamond core cuts faster, smoother and lasts longer than any other core drills.

How to use the diamond core bit:

The diamond core drill bit must be used with water at all times when drilling. The water serves as a coolant to prevent the diamonds from overheating. The maximum allowable temperature for a diamond core bit is 500°C.

There is no pilot drill with the diamond core bit. A low rpm rotary drill with a planetary gearbox is required to be used with a diamond core bit. It is possible to use a cordless drill, but in the lowest gear setting. No hammer action is used.

  1. Tightly fasten the diamond core bit in the drill's chuck.
  2. Keep the bit steady at a 45° angle with the starting point on the edge of the assigned area to be drilled whilst the bit is rotating.
  3. A notch will be made (this is normal). Gradually move the drill from 45° to 90° and continue drilling until finished.
  4. Allow the diamond core bit to cool down completely before proceeding to drill another hole.

Water can be applied by:

  • spraying water on the surface,
  • using a wet sponge,
  • attaching a water feed device. This is necessary when drilling into a wall tile.

Please have a look at the video in the tabs above showing how to use the diamond core bit.

An indication of the correct spindle speed:

DIAMOND CORE BIT DIAMETER SPINDLE SPEED
Ø5.0mm 800 rpm
Ø6.0mm 600 rpm
Ø7.0mm 500 rpm
Ø8.0mm 500 rpm
Ø10.0mm 400 rpm
More than Ø10.0mm (>10.0mm) less than 400 rpm

 

IMPORTANT:
The tool life will mostly depend on the proper usage and the hardness of the items drilled into. It is normal for a diamond core bit to last up to 10 or more drilled holes in hard tiles. Please remember to always use water when drilling with diamond core bits.

 






Copyright © 2024 TechnoPro. Powered by TechnoPro